DIY iPhone or iPod Touch Paper Clip Stand

1. DIY iPhone Stands made from Paper

In order to build this iPhone stand all you need is 270 GSM paper or card stock, a paper knife and a printer. After that, you have to print a template on the your GSM paper or card stock . Then all you have to do is follow the template, cut, fold and you will have you DIY iPhone paper stand. (More information)

Video

Automata iPhone Dock

Automata iPhone Dock. This dock features a mechanism which enables you to change its orientation using wooden gears. It consists of four parts, main iPhone rotating cradle, crank wheel gear, dock base as well as charging cable placement. It’s such a gorgeous wooden craft to display your iPhone.source

Stained Glass iPhone Stand

This stained glass stand for iPhone made by transparent glass and decorated with green glass leaves and red glass flower on adjustable wire is perfect to display your iPhone in an elegant way.source

Step 3: Not Quite There Yet, But Its Looking Good!!!

following on from the last step you need to take the dog-eared edge and fold it back over itself towards the middle basic foldflip the piece of paper over and fold the left side back over itself on the same base line as the triangle, created by the dog-ear folds on the right side. This should create a flap of paper rising out of the base of the triangle and the left side.Thake this flap of paper and fold it over itself towards the left sideFold the remainder of the flap once again back over itself towards the left side.The final image is what your fold should look like from the side

Step 5: So Close Just Keep It Up

Now with the fold underneath the initial triangle fold the two corners of the new right side backwards. make sure that they are even. (the angle of these folds determines the angle at which your iphone will stand) Go back to the flap that you folded over twice in step three and fold it’s edges to meet the line of the triangle you created initially. folded that successfully unfold it and fold line in between the the flaps as described in the sixth picture. Turn the paper over and you are almost ready for final assembly

10. Dinosaur DIY Stand

To finish this post we present you with this funny iPhone stand which you can make by cutting any rubber toy you may have at your home. All you will need is a rubber toy and a knife. (More information)

So, there you have it. 10 DIY tutorials on making your very own iPhone stand. If you end up making any of them, do share the results with us in comments below. If this list isn’t enough, you should perhaps check the below resources for even more DIY stands.

Tags